LASH CLUSTERS Benefits:
Customisable Long Lasting Reusable
8-16MM
How To Apply:
To begin, make sure you are make up and oil free, and completely clean and dry. We recommend working on one eye at a time.
Patch Testing : It is recommended to commence a patch test before using. To do so, apply a small amount of our Bond to a small section of outer corner lashes and wait for 24 hours. If you experience any reactions/sensitivity, please discontinue use.
1. Brush a light coat of "Bond" on your natural lashes. If you are going for a more dramatic look, you may need to take the adhesive further up the lash for a stronger hold. You do not need to brush the adhesive all the way up your lash.
Once the bond is applied, wait for 30 seconds for the bond to go tacky then apply the clusters.
Once you have completed one section, you can then apply the bond to the next section and repeat. Apply the clusters by:
- Loosening and peeling your cluster from the tray as close to the root as possible using your fingers or lash applicator.
-Pick up your cluster from the end section of the lash (not the base.) Place the cluster underneath your natural lashes by lifting the lash cluster against the root of your natural lashes, using an up and out motion.
Once you have applied all lashes to your eyes:
- Apply the 'Seal' using a dabbing motion to the upper and lower sides of your finished lashes. Do not brush or pull the wand through your lash clusters. The seal will eliminate any sticky residue and cure the adhesive bond. ONLY seal the lashes where you've applied the Bond
-Wait 5 minutes to let the cure work it's magic. Repeat this step if you feel the bond is still sticky/tacky.
- Once your lashes are set in place, clamp down the lashes to ensure they are secure and locked into place.
We recommend keeping your lashes away from water and steam for 24 hours after application, just like you would with lash extensions.